Hazardous Area - Fornax - Emergency converted

Emergency Converted

Supplied without lamp

Print this page

An ATEX Category 2 (formerly Zone 1) flameproof luminaire - EEx d.

Application

A general purpose interior or exterior surface or suspended flourescent luminaire for ATEX Category 2 (formerly Zone 1) applications.

Specification

Lightweight slimline compact construction.

2 pack aqua epoxy paint finish on pre-treated and primed surface.

Polycarbonate cover.

Tested to meet ATEX requirements (compulsory since 2003).

Switch start 240V, 50Hz as standard.

Electronic ballast 220 - 250V, 50/60Hz or rapid vivatronic start.

Other voltages and frequencies on request including 110V, 50 or 60Hz options and DC central battery options.

Integral control gear.

Certification data

All options certified for -25°C

8W T5 @ Ta = 40°C T4 @ Ta = 52°C EEx d IIC

18W - T6 @ Ta = 40°C, T5 @ Ta = 55°C, EEx d IIC

36W - T6 @ Ta = 40°C, T5 @ Ta = 55°C, EEx d IIB

58W - T6 @ Ta = 40°C, T5 @ Ta = 55°C, EEx d IIB

70W - T5 @ Ta = 40°C, T4 @ Ta = 55°C, EEx d IIB

2 X M8 tapped mounting holes - vertical and horizontal - at each end.

2 X M 20 - ISO (1 plugged) cable entries each end. Other thread forms available.

3 wire and earth terminals. Cable size 4mm2 max with looping.

Through wiring available on 18W, 36W, 58W and 70W.

2 pack aqua epoxy paint finish on pre-treated and primed surface.

Corrosion resistant anodised light alloy body and covers with polycarbonate overtube.

Certification and Approval

Certification Code:	EEx d II 2 G IIB or IIC T5 - T6 as shown above.
Certification Standard:	EN50014-018
Certification Number:	SIRA 01 ATEX 1033
Degree of Protection:	IP66 to IEC 529

Variations

Vibration resistant base mounted lamp versions available for shipboard use.

Voltage options.

Compact options available.

Through wiring available, saving time on large installations (in 8 and 18w only).

Measurements

Ordering