MI-MCP Addressable Manual Break Glass Call Point

Features

Direct decade addressing (01-99).

Built-in electronics.

Fast response.

LED shows polling (optional) and activation.

Flush or surface mounting.

Up to 99 per loop (+99 analogue sensors).

LPCB approved.

Simple to test.

Designed to the requirements of BS5839, Part 2.

IP67 rated model.

The MI-MCP-GB is designed to provide a manual alarm interface to the ZX & DX series intelligent multiprotocol fire alarm control panels.

The units are fitted with a built-in monitoring module, which provides an interface to the detection loop. The address of the call point is simply "dialed in" using the rotary switches on the rear of the unit.

The call points may be used in most environments as a convenient and quick way of raising an alarm. It is generally installed by exit doors to be operated as people leave a building.

For surface mounting a M500KACGB, a matching plastic back box complete with cable terminations is used. If flush mounting is required a single gang, standard electrical knock-out box may be used in conjunction with a terminal tray for cable connection.

The MI-MCPW-GB is supplied with a back box and is suitable only for surface mounting.

A micro-switch within the unit is held "off" by the edge of the glass. When the glass is broken the switch is released and a signal is transmitted to the control panel where the alarm is raised. The glass is plastic coated to eliminate any danger of splinters causing injury.

A specialist test key (provided) may be pushed into the bottom of the unit to lower the glass and release the micro-switch.