Jupiter

Supplied complete with lamp

< PREVIOUS | NEXT >

 Black base

White base

Semi-recessed bezel

An aesthetically pleasing IP65 rated luminaire with black base and clear prismatic diffuser, ideal for many situations both internal and external.

Porches, toilets, amenity areas, schools, corridors, etc.

Body and diffuser are manufactured from impact resistant polycarbonate.

16w, 28w and 38w 2D lamp variations as standard.

Available with White Base.

Semi-Recessing bezel to allow installation into suspended ceilings.

Also available with sensitive occupancy sensor. Add suffix /OS.

Available with integral emergency pack - see page 5.34.

MICRO-WAVE SENSOR AND PHOTO-CELL.

Switches on automatically when occupancy is detected and the ambient light-level is below a threshold level and off again when no further occupancy is detected.

Manual over-ride is available with a hand-held remote control (E016452) or a conventional switch.

Manual over-ride does not isolate the fitting, so operation via the sensor will be resumed when the area has been vacated.

The micro-wave sensor has a number of unique advantages over traditional passive infra-red sensors.

• It is mounted behind the diffuser and therefore does not compromise luminaire appearance, IP rating or vandal resistance.

• A larger detection zone than a PIR sensor. Ideally suited for use in larger areas such as corridors.

• Wide detection area allows wiring for two-way master/slave operation. e.g. a corridor could have a fitting complete with a sensor at each end and all the intervening fittings are wired so that if either sensor should detect movement the entire corridor will be lit.

The J2D Semi-Recessed bezel cut out size is 255mm square.

See page 13.11 for full fixing centre layout diagram.