Purlieus

Supplied complete
with lamp

< PREVIOUS | NEXT >

A linear vandal resistant IP65 surface mounted fitting ideal for internal and external applications, particularly in onerous environments prone to vandalism.

Police cells / prison areas, hospitals, subways, pedestrian areas and any hostile environments prone to vandalism.

Heavy gauge seam welded body with flat prismatic diffuser, as standard.

Profiled reeded polycarbonate diffuser available.

Stainless steel vandal resistant screws to prevent unauthorised access.

High frequency gear.

Fused terminal block.

Conduit fixing provision via central cable entry.

Finished in the patent Grey Rezi-Seal (RAL 9006) coating providing a weather proof finish and high quality appearance, or Pearl Rezi-Tex for interior applications.

Fitted with Triphosphor colour 84 lamps.

Brackets available to enable corner installation of luminaires.

Profiled reeded polycarbonate diffuser.

Occupancy Sensor option available.

Emergency options also available. See page 5.28

As for UK market.

MICRO-WAVE SENSOR AND PHOTO-CELL.

Switches on automatically when occupancy is detected and the ambient light-level is below a threshold level and off again when no further occupancy is detected.

Manual over-ride is available with a hand-held remote control (E016452) or a conventional switch.

Manual over-ride does not isolate the fitting, so operation via the sensor will be resumed when the area has been vacated.

The micro-wave sensor has a number of unique advantages over traditional passive infra-red sensors.

• It is mounted behind the diffuser and therefore does not compromise luminaire appearance, IP rating or vandal resistance.

• A larger detection zone than a PIR sensor. Ideally suited for use in larger areas such as corridors.

• Wide detection area allows wiring for two-way master/slave operation. e.g. a corridor could have a fitting complete with a sensor at each end and all the intervening fittings are wired so that if either sensor should detect movement the entire corridor will be lit.

 (top) Profiled Reeded Polycarbonate Diffuser (/PRD) and
(bottom) with Flat Panel Diffuser (STANDARD)

Back to top