Instruction Leaflets
E016495

E016495

Sensor, 230v microwave and photocell, 30m range 10AX switched-live output with IR over-ride.

Designed for use in aisles, corridors, school halls and other large spaces where a PIR would not give sufficient coverage. This microwave sensor switches lights (or other loads) on when it detects movement while the ambient light is below a threshold level and off again when no further movement is detected. Switched-live outputs, with adjustable lux threshold and time-out, and with the facility to over-ride the sensor using a hand-held infra-red remote control (E016452).

This sensor is for installation in suspended and plasterboard ceilings, or can be screwed direct to a BESA box for surface mounting.

E016496

Sensor, 230v microwave and photocell, 30m range switched-live output with IR over-ride and DSI output.

As E016495 (above), but with a combined switched live and DSI output. When movement is detected while the ambient light is below a threshold level this sensor will switch the lights on and adjust the light level via a DSI control signal.

The end-user can further adjust the level using the hand-held infra-red remote control (E016452). This sensor must be used in conjunction with appropriate (DSI) control gear.

E016497

Sensor, 230v microwave and photocell, 60m range 10AX at 230v VFC with IR over-ride in a rugged case.

Designed for use in sports halls and on industrial premises where a rugged construction and IP66 rating is necessary.

This unit switches lights on when movement is detected while the ambient light is below a threshold level and switches the load off again when no further movement is detected.

It is in one piece and comes complete with an adjustable mounting bracket. Adjustable light-level threshold and time-out. 10AX rated volt-free contacts with over-ride via an optional hand-held infra-red remote control (E016452).