|
|
|
|
|
|
|
|
|
|
|
SECTION
0.10/11/12
|
You are at: ABOUT US > EXODUS CONTROLS > PRODUCT RANGE (Sensors) |
EXODUS
|
|||||||||||||||||||||||||||
|
| General purpose sensors > Microwave Sensors | |||
|
|
E016476 |
Sensor, 230v PIR and photocell 6A switched-live output. |
Simple and economical, it switches lights on when it detects movement while the ambient light is below a threshold level and off again when no further movement is detected. 6A rated with adjustable time-out and lux-level threshold. |
|
E016493 |
Sensor, 230v PIR and photocell 6A switched-live output with IR over-ride. |
As E016476 (above) but with the addition of the facility to over-ride the sensor using a hand-held infra-red remote control (E016452). |
|
|
|
E016494 |
Sensor, 230v PIR and photocell 6A switched-live output with IR over-ride and DSI output. |
As E016493 (above), but with a combined switched live and DSI output. When movement is detected while the ambient light is below a threshold level this sensor will switch the lights on and generate a DSI control signal. The end-user can further adjust the level using the hand-held infra-red remote control (E016452). This sensor must be used in conjunction with appropriate (DSI) control gear. |
|
H137602 |
Surface mounting box for PIR sensors. |
When a sensor cannot be flush mounted it can be surface mounted using this accessory. The surface mounting box has trunking knockouts and can be fixed to a BESA box or direct to the ceiling. |
|
|
Detection area diagram for PIR occupancy sensors listed above. |
|
|||
|
For flush-mounting
PIR occupancy sensors the cut-out diameter |
||||
|
Back to top |
||||
